Register immediately
View: 36|Reply: 0
Print Prev. thread Next thread

How To Operate The Supporting Machine Of The Marble Cutting Saw Blade?

[Copy link]

48

Threads

49

Posts

226

Credits

Lv.3 Junior Member

Rank: 2

Credits
226
Jump to specified page
The Landlord
Post time 2021-11-28 05:25:35 | Show the author posts only Reply Awards |Descending |Read mode
Edited by alexmax1 at 2021-11-28 05:27

Follow these instructions to operate the supporting machine of the marble cutting saw blade:

1. When assembling, make sure whether the arrow direction of the marble cutting piece is consistent with the axis rotation direction of the equipment spindle.

2. When installing the marble cutting blade, keep the shaft, chuck and flange clean, and the inner diameter of the flooding disk and the inner diameter of the saw blade should be consistent.

3. Make sure that the flange and the marble cutting blade are tightly combined. Install the positioning pin and tighten the nut. The size of the flange should be appropriate and the outer diameter should not be less than one-thirtieth of the diameter of the saw blade.

4. Before starting the equipment, under the condition of ensuring safety, there must be a single person to operate the equipment, jog idling, and check whether the steering of the equipment is correct and whether there is vibration.

5. After installing the marble cutting disc, it should be idling for a few minutes. If there is no slip, swing or jump, then it can work normally.

Origin address: https://www.wanlongstone.com/machine-of-the-marble-cutting-saw-blade.html

Reply

Use magic Report

You have to log in before you can reply Login | Register immediately

Points Rules

Privacy Policy|Creative-Destruction  

2022-1-26 00:36 GMT-5 , Processed in 0.031480 second(s), 20 queries .

Powered by Discuz! X3.3

© 2001-2017 Comsenz Inc.

Quick Reply To Top Return to the list